|
 Specials |
| Copy Machines |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
| Fax Machines |
|
|
 |
 |
 |
 |
|
|
|
|
|
|
Copy Boards |
 |
 |
Shredders |
 |
|
Search |
|
|
|
|
| Home
:: Copiers :: Sharp
:: Sharp Copiers Setup Instructions |
| |
 |
AR-162/162S/163/164/201/207
Developer Installation Setup Instructions |
 |
| Part Number: |
Sharp Copiers |
| Price: |
Click Here |
| Shipping: |
Click
Here |
| Accessory Pricing: |
Click Here |
| Warranty: |
90 Days On-Site Parts and Labor |
| Condition: |
Brand New |
|
|
| |
|
Unpacking and Installation -
Improper installation may damage the copier.
Please note the following during initial installation and whenever the copier is
moved. Failure to follow these instructions or operate copier prior to correctly
completing these instructions voids warranty.
1) Installing conditions
A) Copier installation - Do not install your copier
in areas that are:
- damp, humid, or very dusty
- exposed to direct sunlight
- poorly ventilated
- subject to extreme temperature or humidity changes, e.g., near an are
conditioner or heater
- Be sure to allow the required space around the machine for servicing and
proper ventilation.
B) Power Source
- Use an exclusive-use power outlet. If the power plug of this machine is
inserted into a power outlet commonly used with other illumination units,
flickers of the lamp will result. Use a power outlet which is not commonly
with any illumination units.
- Avoid complex wiring.
C) Grounding the wire connection.
- To avoid danger, be sure to connect a grounding wire. If no grounding
wire is connected and leakage occurs, a fire or an electrical shock may
occur.
2) Removal of protective material and fixing screw.
A) Remove all tape and protective material.
- Remove all tapes, then open the document cover and remove the protective
materials of sheet shape.
B) Remove the fixing screw.
- Use a coin to remove the optic fixing screw located on the
upper-left-side exterior panel.
- The fixing screw is required when transporting the machine. There is a
slot to store it in the paper tray.
Developer Installation -
This procedure MUST be preformed BEFORE
installing toner or powering on a new machine.
1) Open the manual tray, and open the side cover.
2) Open the front cover (Hold both sides and pull down to open).
3) Loosen the blue or green mettalic screw and remove the developer cartridge.
Note: When handling the
developer unit be careful not to bend or distort the plastic shield just above
the magnetic roller.
4) Remove the 3 brass colored screws which fix the toner hopper and Developer
unit then separate the two halves.
5) Supply developer along the developer tank and over the stirring auger.
Note: Shake the
developer bag enough before opening it. Be careful not to splash developer
outside Developer unit. THE ENTIRE CONTENTS OF THE DEVELOPER BAG RE REQUIRED.
If necessary turn the screw on the end of the magnetic roller CLOCKWISE to
allow more room.
6) Attach the developer tank to the developer cartridge.
Note: After supplying
the developer into the developer cartridge, do not tilt or shake the developer
cartridge.
7) Attach the developer cartridge to the copier, and fix it with the screw.
8) Assure that all setup procedures are correctly completed and apply power to
the copier for the first time.
Note: The copier will
now self-calibrate. THIS PROCESS MAY TAKE UP TO 5 MINUTES AND MUST NOT BE
INTERUPTED.
9) When the green Stat Key indicater comes on steadily the copier is ready to
make copies.
|
|
|
|
